[Public-list] Sink Pump Priming

Jock McClees mccleesj at starpower.net
Sat Jun 12 20:15:00 PDT 2004

I replaced my hose a couple of years ago going from the water tank below the
V berth to the sink and couldn't get it to draw. I then noticed that the
hose was flat as a pancake where there was just air. I made sure the hose
was full of water, struggling to keep water all the way to the top while
connecting to the galley sink. But after several efforts, it would draw
again just fine without replacing any parts. Don't know if that helps at
Jock McClees
----- Original Message -----
From: "Peter Amos" <p.a.amos at tesco.net>
To: "Alberg 30 Public List -- open to all" <public-list at alberg30.org>
Sent: Wednesday, June 09, 2004 5:25 PM
Subject: Re: [Public-list] Sink Pump Priming

> If you removed hoses from filter and  pump and transposed them when
> reconnecting that may do it as I know from personal experience.
> Peter Amos
> Tait Tait #478
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list


More information about the Public-List mailing list