[Public-list] Alcohol Stove

[William Wallace]

On my old Coleman camp stove I had to rotate the pump shaft to get a 
good seal on the pump.

Scott
On Monday, June 21, 2004, at 10:35 PM, Todd Redhead wrote:

> Thanks Scott,
>
> The tank will hold pressure if pressurized - I managed to get the pump 
> to
> 'catch' a couple of times and the tank did pressurize.  The main 
> problem is
> that most of the time the pump pushes down without any air going into 
> the
> tank.
>
> Todd
>
> ----- Original Message -----
> From: "William Wallace" <tristan at one.net>
> To: "Alberg 30 Public List -- open to all" <public-list at alberg30.org>
> Sent: Monday, June 21, 2004 10:26 PM
> Subject: Re: [Public-list] Alcohol Stove
>
>
>> Hi Todd,
>>
>> Check your tank cap gasket...
>>
>> Scott
>> On Monday, June 21, 2004, at 10:23 PM, Todd Redhead wrote:
>>
>>> Hello All,
>>>
>>> I'm having a problem with my alcohol stove - a Homestrand.  I can't
>>> seem to prime the pump.  I'm used to a campstove that had a pump with
>>> a leather O ring but this one is rubber.  It just does not seem to be
>>> tight enough to pressurize the tank.  It was working properly for the
>>> winter and the spring but now - its not.  Anyone have any ideas?
>>>
>>> Thanks,
>>>
>>> Todd
>>> _______________________________________________
>>> Public-list mailing list
>>> Public-list at alberg30.org
>>> http://alberg30.org/mailman/listinfo/public-list
>>>
>>
>> _______________________________________________
>> Public-list mailing list
>> Public-list at alberg30.org
>> http://alberg30.org/mailman/listinfo/public-list
>>
>> __________ NOD32 1.742 (20040428) Information __________
>>
>> This message was checked by NOD32 Antivirus System.
>> http://www.nod32.com
>>
>>
>
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list
>


 1087872655.0