[Public-list] what to do with shaft when the engine is gone?

[Mike Lehman]

Why not unscrew the cutlass bearing housing on the backside of the keel and 
screw a bronze cap over the stern tube. That way the shaft can be 
re-installed at a later date if need be. Otherwise, I would remove 
everything and glass over the hole from inside and out.



Mike Lehman
"Gilleleje" #505

~~~_/)_/) ~_/) ~~





----Original Message Follows----
From: "Finkenberg, Lincoln S." <lsfinkenberg at bryancave.com>
Reply-To: Alberg 30 Public List -- open to all <public-list at alberg30.org>
To: "Alberg 30 Public List -- open to all" <public-list at alberg30.org>
Subject: [Public-list] what to do with shaft when the engine is gone?
Date: Mon, 10 May 2004 10:18:57 -0400


	I've no longer a need for an inboard - so that leaves me with
what to do about the shaft.  My thought is to leave it in - IF leaving
it in ain't gonna sink the boat.

	Or how do you take it out and plug the hole? It all seems simple
enough - but none my first time projects end-up that way.

	Thanks, Linc

This electronic mail message contains information that(a)is or may be
LEGALLY PRIVILEGED, CONFIDENTIAL, PROPRIETARY IN NATURE, OR
OTHERWISE PROTECTED BY LAW FROM DISCLOSURE, and(b)is intended only
for the use of the Addressee(s)named herein. If you are not the
intended recipient, an addressee, or the person responsible for
delivering this to an addressee, you are hereby notified that
reading, using, copying, or distributing any part of this message
is strictly prohibited. If you have received this electronic mail
message in error, please contact us immediately and take the steps
necessary to delete the message completely from your computer system.
Thank you.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list



 1084203231.0