[Public-list] winch handle for original mast winch

[John Irving]

A couple of added dimensions:

Thickness of the shaft at winch end: 7 mm (5/16")
After 78 mm (2 7/8") of the above thickness, it becomes: 9mm (3/8")
for the remainder of the shaft.


On Wed, 3 Nov 2004 20:32:12 -0500, John Irving <a30blueteal at gmail.com> wrote:
> I've got one right here.
> 
> Shaft length:  285 mm (about 11 1/4")
> Shaft width at base: 36 mm (1 7/16")
> Shaft tapers to width at handle: 31 mm (1 1/8")
> Handle length: 95 mm (3 11/16")
> Handle width at attachment to handle: 31 mm (1 1/8")
> Handle tapers to width at top: 35 mm (1 3/8")
> 
> Good luck!
> 
> John
> 
> 
> 
> 
> On Wed, 03 Nov 2004 20:06:59 -0500, Brian and Elaine Timmins
> <timmins at optonline.net> wrote:
> > Difficult maybe, irreplaceable? No.
> > You'll need the dimensions of the old handle (tough to get I guess) or the
> > dimensions of the slot in the winch. Post them to the group, and check any
> > consignment / used gear stores near you. Are you in or near Annapolis? Try
> > Bacon's.
> > Good Luck,
> > Brian   ex#497
> >
> >
> > > >
> > > > I am crewing on an Alberg 30 whose main halyard uses one of the original
> > > > winches located
> > > > on the mast itself. While raising the main the other day the winch
> > handle, old
> > > > but
> > > > hopefully not irriplacable, flew out of its pocket and into the sea.
> > Does
> > > > anyone know of
> > > > anyway I can replace this for my captain???
> > > >
> >
> > _______________________________________________
> > Public-list mailing list
> > Public-list at alberg30.org
> > http://alberg30.org/mailman/listinfo/public-list
> >
>

 1099534465.0