[Public-list] Masthead Toggles

[sousa, stephen (ENG)]

I spoke with the shop this morning, the toggle referenced will fit into the
mast head by applying a few methods. If you squeeze the toggle in by a 1/16
of an inch it will fit into the mast head, the other fix is take off 1/16 of
an inch with a file or grinder. The toggle should be modified not the mast
head.

Stephen

 

-----Original Message-----
From: public-list-bounces at alberg30.org
[mailto:public-list-bounces at alberg30.org] On Behalf Of greeksailor at att.net
Sent: Saturday, April 09, 2005 6:49 PM
To: Alberg 30 Public List -- open to all
Subject: RE: [Public-list] Masthead Toggles

Stephen and all,

Today I stepped the mast and found the forestay 6 inches shorter without the
new toggle, so I used the aft most pin on the bow plate with only a few
turns on the turnbuckle to keep the stay on. 

The 1/2 hole in the new mast head seems to be 1/4 inch too high for these
toggles. If the hole was 1/4 lower, these toggles would fit perfectly. Which
causes me to think that probably there could of been an error in the shop.

Whatever the case I'm sure we will find something.

Chris 
Kasia#383

-------------- Original message from "Chris Lawrence"
<chris.lawrence at sympatico.ca>: -------------- 


> Chris - I had the same problem exactly. I have emialed Stephen to find out

> because it looks like the head may have been made a little bit tighter
than 
> was intended. I am wondering if we can file back the aluminium grooves
just 
> enough to allow the toggle to fit...? 
> I will wait and see what Stephen says since it seems this is a common 
> problem 
> 
> Chris Lawrence 
> 24 Scarborough Road 
> Toronto, Canada M4E 3M5 
> T: 416-698-5136 F: 416-698-8953 E: chris.lawrence at sympatico.ca 
> 
> 
> -----Original Message----- 
> From: public-list-bounces at alberg30.org 
> [mailto:public-list-bounces at alberg30.org] On Behalf Of Christos Katehis 
> Sent: 08 April 2005 22:45 
> To: 30 list A 
> Subject: [Public-list] Masthead Toggles 
> 
> 
> Hello all; I tried to use the Schaefer Toggle #93-87, West Marine part 
> #285595 and it did not fit. It was too large. The 1/2 pin fits but the
body 
> ofthe toggles is too large to fit the new mast head. Does anyone know what

> they've used? 
> 
> Chris 
> Kasia#383 
> _______________________________________________ 
> Public-list mailing list 
> Public-list at alberg30.org http://alberg30.org/mailman/listinfo/public-list 
> 
> _______________________________________________ 
> Public-list mailing list 
> Public-list at alberg30.org 
> http://alberg30.org/mailman/listinfo/public-list 
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list

 1113222637.0