[Public-list] how do you back this darn thing up?

Dave Terrell DTERRELL at message.nmc.edu
Wed May 11 09:12:40 PDT 2005


I understand and can say from experience that getting an Alberg to steer well in reverse is a common problem. I end up dealing with this as a sometimes frustrating learning experience.

Why to you have to back in? I have a slip and go in bow first. I back out. I have the good fortune of having a slip that favors the use of the left prop walk of the propeller, but that does not always help in certain winds. In that case I use a line attached to the dock to pull the stern so that the bow heads down the fairway to the bay and  not up the fairway toward the wall. Sometimes that happens and then backing and filling usually gets me out of a jam. My experience suggests that backing out rather than backing is gives the helmsperson more control over the situation. I use a bridle to help with getting into the slip with reasonable grace.


I do have a three questions/suggestiions that might help even if you have to back into your slip.

1. Can you approach the slip in a way that takes advantage of the prop walk? If as you back into the slip, the slip is on your port side, this should be possible. If I have this correct, prop walk will tend to put the boat to port. As you put the tiller to starboard, this will help get you going in the direction that will help.If I have the facts exactly opposite of reality, I hope someone on the list will straighten it out. I am sure the principle is correct even if the data is a little mixed up. I think both principle and data are correct, but... I have to make an effort to clear this up in my mind each spring. 

2. I  have found that putting some  power on in reverse helps the boat go where you want it to go better. If you have too little power on, it is hard to steer any course. On occassion, I found that the boat went quite straight in reverse with lots of power on. Powering up a bit should help.

3. Could you use an inverted version of backing and filling to control the process of backing into the dock? I am not sure I can describe this, but I am sure others can.

4. Can you set up a line on a piling that you could grab as you come in and help control the process?

5. With some analysis, can you pinpoint what worked when you got in the slip correctly? And what did not work when you had to try again? Since I do not back in I have no clues on this from personal experience, but think this might be a helpful line of thinking to pursue.

One caveat - I sail in the great lakes where current and tide are not an issue. I do not know how current or tide might complicate this process.

i hope I have been helpful because I have experienced this frustration myself in different situtations.


>>> jschueler at familyempowerment.org 05/11/05 10:13 AM >>>
Hello all.
 
Having sailed my Alberg last year I am fairly familiar with the problems
that seem to exist when attempting to steer a short course in reverse.
It doesn't appear that it responds well to the rudder, at best; at
worst, there have been times when I've had the boat headed in the
opposite direction to that which I was steering (in reverse). My problem
is this: I am not at a mooring this year as I was last year. I now have
to back the boat into a rather narrow slot between two pilings which
puts the stern to the dock and enables us to get off. However, it's
tough to say the least. I tried 6 times yesterday before I was able to
get it into the slip. I'd put it in reverse and the boat would just back
up in any direction it wanted, no matter that I was guiding it with the
rudder. A whole season of this is going to be a pain in the neck. Any
advice?
 
James Schueler
'Oddyseus' #170
_______________________________________________
Public-list mailing list
Public-list at alberg30.org 
http://alberg30.org/mailman/listinfo/public-list 



 1115827960.0


More information about the Public-List mailing list