[Public-list] RE: Public-list Digest, Vol 539, Issue 1

[Cole, Andrew L]

Ours came (from the prior owner) mounted on the starboard bulkhead.  The
bottom of the the table rests on the top of the seat in front of the
cushion.  The top is held in place by two L shaped pieces of teak bolted
to the bulkhead.  The teak pieces swivel horizontally to release the
table and vertically to hold the table.

It means giving up a fair bit of bulkhead space, but it is very easy to
stow and break out.  I find I use the table a lot more than I would if
it were all the way up in the V-Berth overhead.

Andrew
Andante - 152

>>According to the association web page the missing
>>parts are a block of wood and a barrel bolt, which I
>>assume must engage a hole in the table.

>>Is that correct?  If so, is it adequate?  If not what
>>alternate mounting is preferred?  

Cole, Andrew L
Admitted in Maryland, Virginia & Florida
One Corporate Center
10451 Mill Run Circle, Suite 1000
Baltimore MD 21117

 
tel: 410 581-7408
fax: (410) 581-7410
mob: (410) 206-3577

--------------------------------------------------------
This message contains confidential information and is intended only for public-list at alberg30.org. If you are not public-list at alberg30.org you should not disseminate, distribute or copy this e-mail. Please notify andrew.cole at llff.com immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. Cole, Andrew L therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.
--------------------------------------------------------

 1132154813.0