[Public-list] Rotary Tool

[Rob Alley]

You might also look at laminate cutters--they are like routers but have 
smaller bases, and can cut a set angles..  They are normally used to 
cut/trim laminates glued to other surfaces, like counter tops.  
Otherwise like a router.  If angled with a long bit, can usually be made 
to work flush against edges and in corners.

Rob

Cole, Andrew L wrote:

>The Dremel has an attachment that is a rotary saw (looks like a drill
>bit).  It has a small base (looks like a small router base) that has a
>1" or so radius.  If you need to get really close, you can remove the
>base and get right into the corner (but you lose your uniform depth
>control).
>
>I used the Dremel rotary saw to cut out heating registers in 3/4 inch
>bamboo flooring that I installed.  It got hot and scorched a little, but
>it made the cuts.  I don't think it would have much trouble going
>through fiberglass (although it will probably create a lot of little
>tiny nasty fiberglass fragments).
>
>Andrew
>
>  
>
>>Yes, like a router but with a smaller base so that I can get closer to
>>    
>>
>the
>  
>
>>sides.
>>    
>>
>
>  
>
>>Gord  
>>    
>>
>
>Cole, Andrew L
>Admitted in Maryland, Virginia & Florida
>One Corporate Center
>10451 Mill Run Circle, Suite 1000
>Baltimore MD 21117
>
> 
>tel: 410 581-7408
>fax: (410) 581-7410
>mob: (410) 206-3577
>
>--------------------------------------------------------
>This message contains confidential information and is intended only for public-list at alberg30.org. If you are not public-list at alberg30.org you should not disseminate, distribute or copy this e-mail. Please notify andrew.cole at llff.com immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. Cole, Andrew L therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.
>--------------------------------------------------------
>_______________________________________________
>These businesses support your Association:
>http://www.alberg30.org/store/A30supporters.html
>Please support them.
>_______________________________________________
>Public-list mailing list
>Public-list at alberg30.org
>http://alberg30.org/mailman/listinfo/public-list
>
>  
>

 1142364695.0