[Public-list] Rotary Tool

[Cole, Andrew L]

The Dremel has an attachment that is a rotary saw (looks like a drill
bit).  It has a small base (looks like a small router base) that has a
1" or so radius.  If you need to get really close, you can remove the
base and get right into the corner (but you lose your uniform depth
control).

I used the Dremel rotary saw to cut out heating registers in 3/4 inch
bamboo flooring that I installed.  It got hot and scorched a little, but
it made the cuts.  I don't think it would have much trouble going
through fiberglass (although it will probably create a lot of little
tiny nasty fiberglass fragments).

Andrew

>Yes, like a router but with a smaller base so that I can get closer to
the
>sides.

>Gord  

Cole, Andrew L
Admitted in Maryland, Virginia & Florida
One Corporate Center
10451 Mill Run Circle, Suite 1000
Baltimore MD 21117

 
tel: 410 581-7408
fax: (410) 581-7410
mob: (410) 206-3577

--------------------------------------------------------
This message contains confidential information and is intended only for public-list at alberg30.org. If you are not public-list at alberg30.org you should not disseminate, distribute or copy this e-mail. Please notify andrew.cole at llff.com immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. Cole, Andrew L therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.
--------------------------------------------------------

 1142356338.0