[Public-list] Atomic four intake seacock location

C.B. Currier cbcurrier at spinrx.com
Thu Apr 26 09:10:10 PDT 2007


I don't get it!

Why move anything in the first place?  A good diesel should be more up top
then down below. If you want to re plumb then leave the hole and pipe
around  the motor. As for where it is ... it has got to be one of the MOST
accessible locations on the boat. I just launched the other day & lft that
through hull open with no hose yet attached. When the boat was in the wate
I gingerly jumped down the companoinway and shut off the ball valve I have
in place there in seconds. I shipped 3 pumps of water in then out with the
whale pump.

As for the other through hulls ... these boats have been around for 40
plus years ... why is it we have all of these NEO Marine Architects that
want to REDESIGN the boat? It Aint Broke so don't fix it!

-- 
C.B. Currier
Infinity #57
Dabreak #458

Yes 2!


Don Campbell wrote:
> Rachel;
> When you "fill in the others" make sure you do it properly and use a fix
> as suggested by Gougeon's, with a big cone ground out on the outside and
> several layers of glass to equalize and spread the pressures. This is
> not just a simple fix as the adherence of new materials to old is always
> something that is paramount. Just filling in the hole is not sufficient
> surface area bonding to seal the deal as a failure will just pop out the
> plug. Then you will really need to get to that hole with a plug to stop
> the pond from filling and sinking the boat.
>  Don #528
>
>
> Rachel wrote:
>> Mike,
>>
>> I'm not sure what you are referring to as "a lot of work for a little
>> gain."  Do you mean moving the through hull?  I have the old one out
>> already, so it's not a huge project to move it.  I'll have to enlarge
>> the existing one anyway, and I'm already filling in one or two others
>> (that I'm eliminating).
>>
>> Could you clarify a bit?
>>
>> Rachel
>>
>> On Apr 24, 2007, at 9:41 AM, Mike Lehman wrote:
>>
>>
>>> Rachel,
>>>
>>> This sounds like a lot of work, for little gain. I have not seen
>>> another A30 that has done this.
>>>
>>
>> _______________________________________________
>> These businesses support your Association:
>> http://www.alberg30.org/store/A30supporters.html
>> Please support them.
>> _______________________________________________
>> public-list mailing list
>> public-list at lists.alberg30.org
>> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>>
>>
>>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> public-list mailing list
> public-list at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>


 1177603810.0


More information about the Public-List mailing list