[Public-list] bilge epoxy et al

Mike Lehman sail_505 at hotmail.com
Sat Jan 20 08:03:23 PST 2007


Dan - that is a unique solution - just as unique I have been considering 
concrete, after it hardens, then seal it with a layer of glass. These 
solutions all seem a little radical.



Mike Lehman
~~~_/)_/)~~_/)~~~




----Original Message Follows----
From: dan walker <dsailormon at yahoo.com>
Reply-To: Alberg 30 Public List -- open to all 
<public-list at lists.alberg30.org>
To: Alberg 30 Public List -- open to all <public-list at alberg30.org>
Subject: [Public-list] bilge epoxy et al
Date: Fri, 19 Jan 2007 08:56:34 -0800 (PST)

well david i may as well jump in and tell you what i did. may catch hell 
from the list, but when i removed the engine, i kept looking at the grunge 
in the bilge and couldn't figure why it never seemed to dry. then i learned 
of the sand bottom. so stuck my hand down there and realized what i had. 
scooped the sand, oil slime out till i could not get any more, then used a 
shop vac to get the small  loose grains,  then used citrus orange cleaner to 
clean the sides and created a slurry of what was left and vacced that out. 
let it dry in the summer heat a few days, mixed small bactches of west 
system with microballoons poured that across the lowest point, took pieces 
of well cured oak, coated with epoxy,fitted the pieces in the space at the 
bottom,then put a few layers of glass across the bottom and up the sides. 
.will it all hold? i don't know, but give me two years and i will let you 
know. but it sure looks a lot better than before and i have found every 
screw and nut i have
  dropped down there
   dan


---------------------------------
Finding fabulous fares is fun.
Let Yahoo! FareChase search your favorite travel sites to find flight and 
hotel bargains.
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
public-list mailing list
public-list at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

_________________________________________________________________
Type your favorite song.  Get a customized station.  Try MSN Radio powered 
by Pandora. http://radio.msn.com/?icid=T002MSN03A07001


 1169309003.0


More information about the Public-List mailing list