[Public-list] Bulwark Additon

[Mick Taylor]

Hi All,

I'm currently preparing our boat for off-shore use and am replacing 
rotten toe rails with bulwarks.  There are a few issues I'd like some input on.

I'm wondering about replacing the aluminum rivets securing the 
hull/deck joint.  It seems the group recommends changing these for 
machine screws.  The toe rail bolts also reinforce this joint though 
there will be less bolts with the new bulwarks as it will be secured 
to the deck on brackets at 20" spacing.  Was the deck/hull joint 
designed to be secured by the rivets only?

The outside of the hull/deck joint will now be exposed.  I'd like to 
seal the cracks where what appears to be a thin strip of epoxy filler 
that rounds off the joint.  Cracks are difficult to fill as any flex 
in the joint will open the cracks again.  Does anyone have any 
experience in tidying up the joint in situations where the toe rail 
is no longer used?

Finally, anyone have any suggestions for the best lumber to use for 
the bulwarks.  I'm looking at north american hardwoods and like the 
idea of white ash.  Anyone have any suggestions?

Many thanks

Mick
#231


 1181586708.0