[Public-list] Awlgrip question for M Lehman

[dickdurk at atlanticbb.net]

Have a piece of glass available to test your mix for sag, 
etc. before applying to the hull.

MichaelGrosh
#220


On Tue, 22 May 2007 07:29:33 -0700 (PDT)
  Don Lang <potatosailor at yahoo.com> wrote:
> Thanks Mike and J for the replies.
> I will not spray it myself, its far to dangerous for me 
>to do so at my home. Even if I was protected I would be 
>concerned about the over-spray wafting into the neighbors 
>yards. 
> I will either brush it or roll and tip it if I have 
>help. I have really good full face respirators but will 
>look into renting some positive pressure ones for when I 
>paint.
> If anyone has experience brushing or rolling this stuff 
>I'd sure appreciate any tips you may have on applying it.
> So far I've leaned that keeping a wet-edge is really 
>important to prevent lap lines from showing when the 
>coating dries. As is adding thinner every so often while 
>applying the product to maintain the viscosity level. And 
>surface prep; following the manufactures recommended 
>steps with no short cuts.
> 
> Best regards, Don
> 
> 
>       
> ---------------------------------
> Looking for a deal? Find great prices on flights and 
>hotels with Yahoo! FareChase.
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> public-list mailing list
> public-list at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org


 1179917741.0