[Public-list] salon table bracket

[Randy Katz]

Thanks for the suggestions about the table bracket.

I actually did go to one metal fab place in Seattle with the Z tube-- they
said it would cost around $100+ for them to make up the part.  I KNEW there
had to be a less expensive way.

RV stores that I checked had some similar parts, but haven't been close
enough.

I'll check with Glenn Brooks (close by-- amazing!).  I've seen George's
suggestion about the cockpit arrangement for the table also, but too
expensive.  (for this time around)

Thanks again--
Randy Katz
#249
Seattle/Bellingham
#########################

> Message: 1
> Date: Tue, 29 May 2007 15:35:28 -0700
> From: Randy Katz <randyk at bertschi.org>
> Subject: Re: [Public-list] Salon table mounting bracket?
> To: <public-list at lists.alberg30.org>
> Message-ID: <C281F8C0.8CFB%randyk at bertschi.org>
> Content-Type: text/plain; charset="US-ASCII"
> 
> Greetings, All,
> 
>     The previous note about the table base reminds me....   Does anyone know
> where I might find the OTHER end of the table set up?  I have the original
> Z-tube, but the bracket that goes on the actual table and which receives the
> tube-end is that which I seek.
> 
>     I presently have a rather funky set up which essentially works but which
> results in the table being very wobbly.
> 
>     Any thoughts?  Anyone replacing their table who'd part with the table
> mount bracket?  There could be BIG $$$ in this for someone! (ha!)
> 
>     Many Thanks,
> 
> 
>     Randy Katz
> #249  
> Seattle/Bellingham, WA.
> 



 1180653168.0