[Public-list] salon table bracket

[J Bergquist]

I had Atlantic Spars & Rigging in Annapolis fabricate a Z-Leg with a
bracket for me last winter using the pix on the association website.
They made it out of stainless because they said they couldn't get
Aluminum that was the correct size. They charged me $500 for the whole
thing...leg and bracket. I thought it was expensive, but in the end,
it's nice to have a working table leg.

Later,

JB

On 5/31/07, Randy Katz <randyk at bertschi.org> wrote:
> Thanks for the suggestions about the table bracket.
>
> I actually did go to one metal fab place in Seattle with the Z tube-- they
> said it would cost around $100+ for them to make up the part.  I KNEW there
> had to be a less expensive way.
>
> RV stores that I checked had some similar parts, but haven't been close
> enough.
>
> I'll check with Glenn Brooks (close by-- amazing!).  I've seen George's
> suggestion about the cockpit arrangement for the table also, but too
> expensive.  (for this time around)
>
> Thanks again--
> Randy Katz
> #249
> Seattle/Bellingham
> #########################
>
> > Message: 1
> > Date: Tue, 29 May 2007 15:35:28 -0700
> > From: Randy Katz <randyk at bertschi.org>
> > Subject: Re: [Public-list] Salon table mounting bracket?
> > To: <public-list at lists.alberg30.org>
> > Message-ID: <C281F8C0.8CFB%randyk at bertschi.org>
> > Content-Type: text/plain; charset="US-ASCII"
> >
> > Greetings, All,
> >
> >     The previous note about the table base reminds me....   Does anyone know
> > where I might find the OTHER end of the table set up?  I have the original
> > Z-tube, but the bracket that goes on the actual table and which receives the
> > tube-end is that which I seek.
> >
> >     I presently have a rather funky set up which essentially works but which
> > results in the table being very wobbly.
> >
> >     Any thoughts?  Anyone replacing their table who'd part with the table
> > mount bracket?  There could be BIG $$$ in this for someone! (ha!)
> >
> >     Many Thanks,
> >
> >
> >     Randy Katz
> > #249
> > Seattle/Bellingham, WA.
> >
>
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> public-list mailing list
> public-list at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>

 1180654288.0