[Public-List] Paint over epoxy or wood glue?

[dan walker]

roger . do u ever get to lower michigan area? we could sail on my alberg if you like. so u can remember what you are doing all this for
dan

--- On Mon, 4/27/09, Roger L. Kingsland <r.kingsland at ksba.com> wrote:

> From: Roger L. Kingsland <r.kingsland at ksba.com>
> Subject: Re: [Public-List] Paint over epoxy or wood glue?
> To: "'Alberg 30 Public List -- open to all'" <public-list at lists.alberg30.org>
> Date: Monday, April 27, 2009, 10:48 AM
> Gord,
> 
> Based on my past experience, I hope there is a special
> place in heaven for
> the sailor who undertakes the hell of managing two old
> sailboats at one
> time.
> 
> Also speaking of wood, with such great weather in "Da
> Burgh" this weekend, I
> got the new wood winch bases set in epoxy and they do a
> reasonable (not
> perfect, as intended) job of fitting against the outside
> face of the combing
> boards.  I also got the chain plates set and was
> amazed that my over
> analyzed install scheme worked.  Using a gig, I routed
> out holes 1/2" larger
> than the cross section dimension of the CPs (leaves 1/4"
> all round for
> caulking w/ backer rods under) then taped spacers against
> one side to hold
> the CPs at the right height and in the center of the holes;
> after slathering
> on epoxy (the other elixir of the devil) I used shims on
> the other side of
> the hole and clamped the CPs to knees below.  I might
> even be able to
> install the caulking before it rains.  Winches,
> travelers, manual bilge
> pump, cowl vents, deck pipe (if I can find the darn thing),
> and instrument
> panel next.  I think I will hold off on chocks and
> cleats until after
> launch.    
> 
> 
> All the best,
> 
> Roger 148
> 
> 
> -----Original Message-----
> From: public-list-bounces at lists.alberg30.org
> [mailto:public-list-bounces at lists.alberg30.org]
> On Behalf Of Gordon Laco
> Sent: Monday, April 27, 2009 8:49 AM
> To: Alberg 30 Public List -- open to all
> Subject: Re: [Public-List] Paint over epoxy or wood glue?
> 
> Good morning friends -
> 
> The grips of oars are left bare for grip... And the
> double-boiled linseed
> oil is the stuff that treats wood and dries.
> 
> I wouldn't put it on the grips though - those should just
> be left bare wood.
> If they go silver that's OK.
> 
> On the subject of wood - I got TOUCH WOOD's starboard
> garboard strake off
> yesterday, and mostly intact too.  I was afraid to
> look at the keel but much
> to my surprised delight - it is sound and hard as
> rock.  As I was wire
> brushing the decades of crud off it, among the debris that
> came out was the
> 1947 Danish coin I used to keep in the mast step.  It
> was not in its
> position when I got her back and assumed that it was lost.
> 
> I could have wept at the well-meaning but misguided
> 'repairs' she had been
> subjected to... Among them a sort of doubler over the third
> strake up on
> both sides.  The doublers were wide and thin planks of
> red cedar that
> bridged one an a half lapstrakes...leaving a void behind
> and slathered with
> that elixor of the devil - 3M5200.  I got the doublers
> off sliver by sliver
> and found a sound plank beneath.  I will never know
> why they were put on.
> 
> Onwards...
> 
> Gord #426 SURPRISE (and F 16 TOUCH WOOD)
> 
> 
> 
> On 4/27/09 6:17 AM, "Michael" <dickdurk at atlanticbb.net>
> wrote:
> 
> > Linseed oil is the trad. treatment for oar grips- the
> non hardening 
> > kind (I can't remember if that's boiled or raw).
> > The blister prevention thing is overrated, though. I
> participated in 
> > lifeboat races years ago and my hands blistered up
> just fine with bare 
> > wood handles, thankyouverymuch.
> > 
> > MichaelGrosh
> > #220
> > _______________________________________________
> > These businesses support your Association:
> > http://www.alberg30.org/store/A30supporters.html
> > Please support them.
> > _______________________________________________
> > Public-List mailing list
> > Public-List at lists.alberg30.org
> > http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> 
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> 
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> 


      

 1240845266.0