[Public-List] dripless
C.B. Currier
cbcurrier at spinrx.com
Fri Jun 5 07:47:41 PDT 2009
You can pretty much pull the nut off and water flows in but as long as
you are prepared to pull the old stuffing out & push new in, you will
be fine. The hard part is laying over the motor.
--
C.B.
Currier
Inifinity #57
Daybreak #458
Bobby wrote:
>
> Hey George,
>
> For that dripless
packing, can one install this whilst the boat is in the
> water or
will the boat need to be hauled out? Does it need curing time
>
before getting wet or will the water flowing in impede the
installation?
>
>
>
> --- On Fri,
6/5/09, George Dinwiddie <gdinwiddie at alberg30.org> wrote:
>
>
>
From: George Dinwiddie
<gdinwiddie at alberg30.org>
> Subject: Re: [Public-List]
Source of bilge water
> To: "Alberg 30 Public List -- open to
all"
> <public-list at lists.alberg30.org>
> Date:
Friday, June 5, 2009, 1:46 AM
>
>
> John
Brugeman wrote:
>> To anyone,
>>
>> What
is the drip rate for the stuffing box on the prop shaft when
>>
running? I think I have tightened mine to tight because it is not
>> dripping at all. Previously, I was pumping about 2 gallons per
week
>> out of the bilge.
>
> John, with
ordinary flax packing, a drip every few seconds is normal while
>
the shaft is turning. It shouldn't drip at all when not turning.
>
> I use a clay-like packing that allows it to not drip at
all. See
>
http://alberg30.org/maintenance/MechanicalPropulsion/StuffingBox/ for
more
> details.
>
> - George
>
>
--
----------------------------------------------------------------------
> When I remember bygone days George
Dinwiddie
> I think how evening follows morn;
gdinwiddie at alberg30.org
> So many I loved were not yet dead,
http://www.Alberg30.org
> So many I love were not yet
born. also see:
> 'The
Middle' by Ogden Nash http://idiacomputing.com
>
----------------------------------------------------------------------
>
>
>
>
_______________________________________________
> These businesses
support your Association:
>
http://www.alberg30.org/store/A30supporters.html
> Please support
them.
> _______________________________________________
>
Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>
>
>
>
>
_______________________________________________
> These businesses
support your Association:
>
http://www.alberg30.org/store/A30supporters.html
> Please support
them.
> _______________________________________________
>
Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>
1244213261.0
More information about the Public-List
mailing list