[Public-List] Stern Gland Housing Question

[Stephen Sousa]

Mick,

 

The cutless has the bronze and rubber on our boats. If you have a 7/8" shaft, the Barracuda from Buck fits our application.

 

Stephen 
 
> Date: Sat, 6 Feb 2010 12:35:33 -0800
> From: m_tayau at yahoo.com.au
> To: public-list at lists.alberg30.org
> Subject: [Public-List] Stern Gland Housing Question
> 
> I've just removed the stern gland housing as I want to replace the cutlass bearing. On removal I found there is a bronze bushing inside the housing which is either meant to be part of the housing or part of the bearing. I see that you can buy two types of bearing with or without a bronze backing for the nitrile rubber. I am hoping that the bearing to go back in is one which has the bronze bushing as the bushing I found inside the housing is poor shape. I hope though that it can pressed out easily but it looks like it may be difficult.
> 
> If the bearing is composed of only the nitrile rubber then how should I glue it into the bearing (the rubber is glued onto the bronze bushing on the one I took off). Finally, are the housings still available new?
> 
> Many thanks
> 
> Mick #231
> 
> 
> __________________________________________________________________________________
> Yahoo!7: Catch-up on your favourite Channel 7 TV shows easily, legally, and for free at PLUS7. www.tv.yahoo.com.au/plus7
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
 		 	   		  
_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/201469227/direct/01/
 1265490941.0