[Public-List] Cutlass Bearing Flange. PS
mahseer at kos.net
mahseer at kos.net
Fri Jul 23 10:46:29 PDT 2010
Yes Jeff you can remove the bearing without taking out the casting, just
cut two grooves length wise and remove. When I did mine after pressing in
the new cutlass bearing that was too long I left the exposed section on so
if I have to do it again I can either clamp something or my prefered
method to drill through add a bolt or equivalent bar and pull out, I have
not tried this yet but should work.
John Boor
MAHSEER #380
> I'm glad to have removed all the bedding gunk, but I bet I could have
> removed the bearing in place.
>
1279907189.0
More information about the Public-List
mailing list