[Public-List] Paint hull liner & deck #560

[John Riley]

Mike Lehman wrote:
> Bob,
>
> We have replaced the windows in dozens of Albergs. The process is well
> documented with step-by-step instruction on the A30 website. This is a
> proven technique that has been refined over the years. There are a few
> tricks. If you have questions after reading this, I can clear them up.
> The page you will want to read is....
>
> http://alberg30.org/maintenance/HullDeck/Portlights/
>
>
Very interesting on the use/recommendation of silicon.

I am near the end-stage of completely rebuilding one side of my cabin
trunk due to the utter and complete failure of silicon sealant on the
portlights (and every other single place on the boat that stuff was
used) put in by a previous owner.  We took the frames off to rebed them,
and the whole side of the cabin trunk delaminated in my hand.

A few hours with a grinder to get back to good glass, some marine ply
epoxied into place with glass cloth and mat built up around the fillets
and I am getting close to final glassing and fairing.

I'll not use silicon anywhere on my boat, and a number of old boat
restoration enthusiasts agree:

http://sailfar.net/forum/index.php/topic,85.0.html

As always, your boat, your choices, and your mileage may vary...sealing
portlights is one of the recommended uses, but given my experience?  No
thanks.

Fair Winds,

-- 
John S. Riley
S/V Gaelic Sea
1972 Alberg 30 #521


 1304442834.0