[Public-List] Rachel - Hull thickness question

[Richard Hughes]

Installing a saddle tank in the stb locker to replace the tank under the 
cockpit sole.
I have the tank, courtesy of another member of this site, but now need to 
install a "bracket" to secure it with, which I have fashioned out of epoxy 
coated wood. Now need to gently screw that bracket into the hull wall/side 
while west system sets up, then fibreglass over all.

So, that's my tale, but running out of heat for fibregalss work!

-----Original Message----- 
From: Rachel
Sent: Tuesday, November 08, 2011 7:50 PM
To: Alberg 30 Public List -- open to all
Subject: Re: [Public-List] Hull thickness question

I can't speak to that exact spot, but I removed/replaced or filled all the 
below-the-waterline seacocks on the whole boat and the hull was around 3/8" 
thick (and pretty uniform for all of them  (#221).

I'm trying to remember if I drilled or looked at any holes above the 
waterline... I don't think so, but if I remember any I will reply again.

I'll admit that I'm curious why you are asking :) (But my mind just works 
that way - not that I'm challenging you or anything like that!)

Rachel
ex=#221

On Nov 8, 2011, at 7:06 PM, Richard Hughes wrote:

> Anyone know the thickness of the hull above the waterline, centre of stb 
> cockpit locker?
> Installing new fuel tank.
> Thanks Rick # 438

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org 


 1320812234.0