[Public-List] Early model running light question
Amy & David Swanson
zira at bellsouth.net
Sun Oct 9 15:04:42 PDT 2011
The glass comes out fine. I just can't get the actual contact part out.
Alberg 30 #229
----- Original Message -----
From: "Michael Grosh" <dickdurk at gmail.com>
To: "Alberg 30 Public List -- open to all" <public-list at lists.alberg30.org>
Sent: Sunday, October 09, 2011 6:01 PM
Subject: Re: [Public-List] Early model running light question
> On my '67 boat, the colored lens is glass. It was held in place by
> and had a foamy rubber sort of gasket. As long as a PO didn't get
> the glass should just pop out.
> On Checkmate, I deleted the bulb and fixture with LED. I soldered pigtails
> directly to the 'bulb' contacts, then sealed in the whole mess (inside the
> colored glass) with silicone. Works great-be aware LEDs are polarity
> sensitive, though.
> On Oct 9, 2011 4:23 PM, "Amy & David Swanson" <zira at bellsouth.net>
>> On my 1967 model boat, I am having problems with the starboard (green)
>> running light. I need to disassemble it, and take out the spring-loaded
>> plastic part with the 2 contacts for the bulb. I can get the bronze
>> apart but I cannot figure out how to get that plastic part out. Can
>> give me some guidance, or suggestions on where to get a replacement?
>> David Swanson
>> Strayaway Child
>> Aplberg 30 #229
>> These businesses support your Association:
>> Please support them.
>> Public-List mailing list
>> Public-List at lists.alberg30.org
> These businesses support your Association:
> Please support them.
> Public-List mailing list
> Public-List at lists.alberg30.org
More information about the Public-List