[Public-List] Cabin Sole (or soul)

Glenn via Public-List public-list at lists.alberg30.org
Sat Aug 16 16:39:48 PDT 2014


Try these people.  


I bought 1/2" wide flat rubber gasket material from them in June to renew my hatch gaskets.  It works great.  Its hollow in the center and compresses against the lip of the hatch coaming when the hatch closes- forms a water tight seal. Also has an adhesive tape on one side. Around 45 cents/foot if I remember correctly. 

Glenn B
doce 318

Sent from my iPad

On Aug 16, 2014, at 3:26 PM, Wes Gardner via Public-List <public-list at lists.alberg30.org> wrote:

> My boat will be day sailed almost all of the time so I am going to leave it up to the next owner to reconfigure the interior to match their use of the boat.  For me, the lack of insulation is just not a concern but I will be vigilant in keeping after leaks/rot/structural concerns.
> As far as the cockpit lockers are concerned, it would have been nice to have adequate drain channels around the perimeter but that's not going to happen.
> At the moment, my locker lids don't even have a latch so I do get some water entering there. Any suggestions for a particular type of rubber gasketing/tape?
> Wes
> Sent from my iPad
>> On Aug 16, 2014, at 5:58 PM, Michael Grosh <dickdurk at gmail.com> wrote:
>> The whole Ice box arrangement on the pre liner boat is pretty sketchy. Insulation is just bad. Mine was a single piece of pink panther stuff that had become completely water saturated. 
>> I reconfigured to a chest type.
>> It sure was nice to reach in from the cockpit to grab a cold one though. At least for the day and a half the ice held up.
>> Michael Grosh
>> #220
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org


More information about the Public-List mailing list