[Public-List] Question on removal of sliding hatch on 1977 Alberg

[George Dinwiddie via Public-List]

On 7/15/16 9:35 AM, Bill McCoy via Public-List wrote:
> After exhausting my limited knowledge of basic cabinetry I would like
> guidance on how I might remove the sliding hatch cover on my Alberg
> so that I might work on the teak surface in a protected environment
> which is not 100 degrees.  I have removed the forward "turtle"
> protective cuddy yet cannot determine where the secret notch is which
> will permit me to extract the sliding hatch.
>
> Skeep
> Hull #614

As I recall, I used a right-angle screwdriver to loosen and turn the 
metal tabs that slide along the bottom sides of the rail.

  - George



-- 
  ----------------------------------------------------------------------
   When I remember bygone days                         George Dinwiddie
   I think how evening follows morn;            gdinwiddie at alberg30.org
   So many I loved were not yet dead,           http://www.Alberg30.org
   So many I love were not yet born.                          also see:
                'The Middle' by Ogden Nash     http://idiacomputing.com
  ----------------------------------------------------------------------