[Public-List] Question on removal of sliding hatch on 1977 Alberg

[americo silva via Public-List]

there are 4 bronze plates underneath i used a bent screwdriver to remove
two on one side then the hatch will come off

On Fri, Jul 15, 2016 at 2:03 PM, George Dinwiddie via Public-List <
public-list at lists.alberg30.org> wrote:

> On 7/15/16 9:35 AM, Bill McCoy via Public-List wrote:
>
>> After exhausting my limited knowledge of basic cabinetry I would like
>> guidance on how I might remove the sliding hatch cover on my Alberg
>> so that I might work on the teak surface in a protected environment
>> which is not 100 degrees.  I have removed the forward "turtle"
>> protective cuddy yet cannot determine where the secret notch is which
>> will permit me to extract the sliding hatch.
>>
>> Skeep
>> Hull #614
>>
>
> As I recall, I used a right-angle screwdriver to loosen and turn the metal
> tabs that slide along the bottom sides of the rail.
>
>  - George
>
>
>
> --
>  ----------------------------------------------------------------------
>   When I remember bygone days                         George Dinwiddie
>   I think how evening follows morn;            gdinwiddie at alberg30.org
>   So many I loved were not yet dead,           http://www.Alberg30.org
>   So many I love were not yet born.                          also see:
>                'The Middle' by Ogden Nash     http://idiacomputing.com
>  ----------------------------------------------------------------------
>
>
>
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>