[Public-List] Stern tube

[SNCSoft via Public-List]

On #602 stern tube sealed with some grey/blue resin kind stuff, therefore
tube is quite flexible and should be hold and from inside boat when
unscrewing/crewing shaft log.

New cutlass bearing installed - "Barracuda" 1 3/8 OD x 7/8 ID, 3 1/2
length. After measurement the bearing was cut to 2 7/16 length.

http://www.sncsoft.com/images/forums/IMG_9488.JPG

http://www.sncsoft.com/images/forums/IMG_9492.JPG

http://www.sncsoft.com/images/forums/IMG_9496.JPG

http://www.sncsoft.com/images/forums/IMG_9991.JPG

http://www.sncsoft.com/images/forums/IMG_9994.JPG

http://www.sncsoft.com/images/forums/IMG_0015.JPG

Serguei, #602


> Message: 1
> Date: Mon, 13 Jun 2016 11:12:13 -0400
> From: Wes Gardner via Public-List <public-list at lists.alberg30.org>
> To: Greg Bover <gregbover at cbfisk.com>,  Alberg 30 Public List -- open
>         to all <public-list at lists.alberg30.org>
> Subject: Re: [Public-List] Stern tube
> Message-ID:
>         <CAFWpyHwuJFttHVGYRYAabYhX0=
> OqPRAzXykgKCvuoNAB8w5RFw at mail.gmail.com>
> Content-Type: text/plain; charset=UTF-8
>
> Hey All,
>
> Just from knowledge of cutlass bearings on other boats, 2" seems awfully
> short.  Perhaps this is something a PO did incorrectly???  I have cut them
> down in the past, but not that much...other folks should know what is
> specific to our boats.
>
> Wes
>
>