[Public-List] #56 Topping Lift Question
Don Campbell via Public-List
public-list at lists.alberg30.org
Sun Sep 24 06:44:02 PDT 2017
Yes. There is one in the Canadian fleet. It is a Garhauer and there were
problems setting it up initially. It was fine for the ability to hold the
boom and sail up but on a run, because it was also bing used to hold the
boom down as a vang , it put such force on the track that held the boom that
it pulled the screws holding the track to the mast. The solution was to have
Garhauer make a bracket to hold the boom to the mast and affix it with
better fasteners. Therefore the boom is now in a fixed position above the
deck. It appears to be working well now.
Don Campbell
-----Original Message-----
From: Joseph Balderson via Public-List
Sent: Sunday, September 24, 2017 7:20 AM
To: Alberg 30 Public List -- open to all ; James Cowhey
Subject: Re: [Public-List] #56 Topping Lift Question
Does anyone use a mechanical boom vang of the type which will support the
weight of the boom?
On Sep 23, 2017 5:31 PM, "James Cowhey via Public-List" <
public-list at lists.alberg30.org> wrote:
> Thanks, everyone. I think I'll stick with what I have and maybe upgrade
> to a slightly bigger diameter next season or so. My experience had been
> with wiring so this small braided line was of concern but I understand
> while I'm might be slightly undersized it should keep working properly.
>
> James Cowhey
> Sent from my iPad
>
> > On Sep 22, 2017, at 10:49 AM, Mike Lehman via Public-List <
> public-list at lists.alberg30.org> wrote:
> >
> > Plus...remember that the old wire lift was adjusted from the boom end
> which
> > you could not reach when running down wind.
> >
> > On Sep 22, 2017 8:54 AM, "Gordon Laco via Public-List" <
> > public-list at lists.alberg30.org> wrote:
> >
> >> Good morning –
> >>
> >> We use ¼” polyester double braid for our main topping lift, which
> >> starts
> >> with a snap shackle at the outer end of the boom, goes up to a swivel
> block
> >> at the masthead, then down to a clamcleat on the mast. It’s tail is
> coiled
> >> onto the small spar cleat fitted lower down at the factory.
> >>
> >> Wire was once common for lifts, I think because of the small windage
> they
> >> afford, but on the other hand the wire is thought to beat hell out of
> the
> >> stitching on the leach of the mainsail, so people used to resort to the
> >> awkward expedient of attaching the lift to a ring on the backstay. I
> never
> >> liked that set up because to replace the lift one had to first catch
> >> the
> >> end of the boom. And of course in heavy air when one wants to reef,
> >> re-attaching the lift to support the boom during the procedure can be
> >> dangerous.
> >>
> >> A rope lift doesn’t bother the sail much, can be very easily adjusted
> from
> >> the mast, and on two occasions over thirty years with two boats... that
> >> lift has served as an emergency main halyard.
> >>
> >> Gord
> >> #426 Surprise
> >>
> >> On 2017-09-22, 12:04 AM, "Public-List on behalf of George Dinwiddie via
> >> Public-List" <public-list-bounces at lists.alberg30.org on behalf of
> >> public-list at lists.alberg30.org> wrote:
> >>
> >> James,
> >>
> >> 1/8" seems a bit small, but it could be that the block at the
> masthead
> >> was designed for wire. I think 3/16" or 1/4" line is more common.
> >>
> >> The ones I've seen with wire rope have been fixed at the masthead
> >> and
> >> have a braided line tackle between the wire and the boom. That seems
> >> overkill, to me, as stretch really isn't an issue.
> >>
> >> - George
> >>
> >>> On 9/21/17 10:52 PM, James Cowhey via Public-List wrote:
> >>> This is my first post since taking ownership of #56 Mo Cuisle,
> >> formerly Inherit the Wind. I'v already learned a few things from the
> >> listserv. I'm sure I'll have more questions as I get to know her.
> >>>
> >>> A previous owner rigged the topping lift with 1/8 inch braided
> >> line. I this a racing modification? The line runs from the end of
> boom to
> >> a block at the masthead to a cleat near the bottom of the mast. The
> line
> >> seems too stretchy, but I've only ever seen wire rope topping lifts.
> What
> >> is the preferred or OEM rig for the topping lift on these boats?
> >>>
> >>> I haven't owned a boat in over fifteen years, and I ended up buying
> >> this one in July and it was the first one I looked at when I considered
> >> ownership again. These are special and beautiful boats.
> >>>
> >>> Thanks.
> >>>
> >>> James Cowhey
> >> --
> >> ------------------------------------------------------------
> >> ----------
> >> When I remember bygone days George
> Dinwiddie
> >> I think how evening follows morn;
> >> gdinwiddie at alberg30.org
> >> So many I loved were not yet dead,
> >> http://www.Alberg30.org
> >> So many I love were not yet born. also
> see:
> >> 'The Middle' by Ogden Nash
> >> http://idiacomputing.com
> >> ------------------------------------------------------------
> >> ----------
> >>
> >>
> >>
> >> _______________________________________________
> >> These businesses support your Association:
> >> http://www.alberg30.org/store/A30supporters.html
> >> Please support them.
> >> _______________________________________________
> >> Public-List mailing list
> >> Public-List at lists.alberg30.org
> >> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> >>
> >>
> >>
> >> _______________________________________________
> >> These businesses support your Association:
> >> http://www.alberg30.org/store/A30supporters.html
> >> Please support them.
> >> _______________________________________________
> >> Public-List mailing list
> >> Public-List at lists.alberg30.org
> >> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> >>
> > _______________________________________________
> > These businesses support your Association:
> > http://www.alberg30.org/store/A30supporters.html
> > Please support them.
> > _______________________________________________
> > Public-List mailing list
> > Public-List at lists.alberg30.org
> > http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
More information about the Public-List
mailing list