[Public-List] stop boom rotation

[Gordon Laco]

Hello again… damned autocorrect… I meant to write ‘…tap threads’ not tape threads.

So if any of you are in the vicinity of Gravenhurst Ontario today, I’ll be manning my display at the Antique and Classic Boat Show there… it’s always good to see friends.

Gordon Laco
www.gordonlaco.com




> On Jul 7, 2018, at 6:22 AM, Gordon Laco via Public-List <public-list at lists.alberg30.org> wrote:
> 
> Good morning Bernard,
> 
> The simplest would be to drill into the worm gear assembly through it’s housing, tape threads in the bronze, then drive in a machine screw.  Ours turns a bit sometimes, but only after a really hard bash in heavy air.  I’ve not bothered to immobilize it yet but keep thinking I should…
> 
> Gordon Laco
> www.gordonlaco.com
> #426 Surprise
> 
> 
> 
>> On Jul 7, 2018, at 12:31 AM, The Rochets via Public-List <public-list at lists.alberg30.org> wrote:
>> 
>> What is the best—and easiest—way to immobilize the boom so it stays straight instead of rotating?
>> 
>> Thank you.
>> 
>> Bernard Rochet
>> Sunswept #608
>> 
>> 
>> _______________________________________________
>> These businesses support your Association:
>> http://www.alberg30.org/store/A30supporters.html
>> Please support them.
>> _______________________________________________
>> Public-List mailing list
>> Public-List at lists.alberg30.org
>> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> 
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org