[Public-List] Traveller Install

[Zachary Smith]

Don't forget to protect the core from water intrusion.

Zach

On Wednesday, May 2, 2018, Mike Meinhold via Public-List <
public-list at lists.alberg30.org> wrote:

> Chris
>  I agree with others that there is no need to build up the curve - just
> bolt it down and it will conform.
>
>   I recommend you use the largest bolts that fit the chamfered holes in the
> track. Use a single backing plate of aluminum or stainless at each end -
> check the bottom surface to make sure you can fit it flat.
>
> Mike
> Rinn Duin #272
>
> On Wed, May 2, 2018 at 11:27 AM, Chris Martin via Public-List <
> public-list at lists.alberg30.org> wrote:
>
> >  Hi Folks
> > I have a new Garhauer traveller to install and am looking for some
> advice.
> > I have lots of questions and figure some have this setup and might have
> > some pointers for installation. I found some good info in the past but
> I'm
> > ready to get some hardware and didnt see that. What size and type
> > screws/bolts did you use? Also, seems like I can fab some tapered wood
> > pieces to mount the under the traveller or try to make the straight track
> > bend to the deck. Not much of a curve but its there. What works? Any
> other
> > issues I'm not thinking about?
> > Thanks
> > Chris
> > _______________________________________________
> > These businesses support your Association:
> > http://www.alberg30.org/store/A30supporters.html
> > Please support them.
> > _______________________________________________
> > Public-List mailing list
> > Public-List at lists.alberg30.org
> > http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> >
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>