[Public-List] Stern Tube Bedding

George Dinwiddie gdinwiddie at alberg30.org
Mon Apr 8 08:04:09 PDT 2019


Andrew,

I used 5200 to reinstall my stern tube. When doing so, I put some 
vaseline on the cutless bearing housing threads and where it would 
contact the 5200 around the stern tube. This was to keep it from 
sticking to the stern tube 5200.

When reinstalling the cutless bearing housing, I also bedded it with 
5200, but I wanted that to be a different blob of 5200 since it's 
removed more often than the stern tube.

BTW, when you need to remove the 5200ed cutless bearing housing, a 
little heat with a propane torch softens the 5200.

Perhaps in your case there it 5200 on the threads. You might try putting 
the cutless bearing housing in a vice, heating it at the joint with a 
propane torch, and turning the stern tube with a pipe wrench. Either 
caulk or corrosion is probably holding it.

I don't worry about the cutless bearing bolts stripping out. I also put 
5200 on them when reinstalling.

  - George

On 4/8/19 10:29 AM, Andrew Johns via Public-List wrote:
> Good Morning,
> In my rapidly snowballing shaft seal project... I have removed the cutlass
> bearing housing to replace worn bearing.
> 
> I removed the bolts holding it to the keel and rotated it with a pipe
> wrench in an effort to get it to thread from the stern tube.  Unfortunately
> the whole bearing housing and stern tube assembly came out as one piece.
> Fortunately its in good shape but the two pieces are hopelessly stuck
> together.
> 
> Looking back though the list it appears Whitby used some sort of caulk to
> bond in the assembly? Dolponite?  What is the groups thoughts on using 5200
> to reinstall the stern tube/ bearing housing?
> 
> Additionally, should I be worried about the threads in the keel striping
> out?  It don't appear to have any metal inserts or anything of that sort.
> 
> Thanks,
> Andrew Johns
> Ecola # 104
> Colchester VT
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> 
> 

-- 
  ----------------------------------------------------------------------
   When I remember bygone days                         George Dinwiddie
   I think how evening follows morn;            gdinwiddie at alberg30.org
   So many I loved were not yet dead,           http://www.Alberg30.org
   So many I love were not yet born.                          also see:
                'The Middle' by Ogden Nash     http://idiacomputing.com
  ----------------------------------------------------------------------






More information about the Public-List mailing list