[Public-List] Tiller to Rudder Connection

Gordon Laco mainstay at csolve.net
Thu Mar 28 14:01:25 PDT 2024


I’d agree with Stephen about Edson.

They made the rudder fittings our boats were fitted with when Alberg 30’s were in production, and Edson still has the original patterns from which they could make them again… but they don’t seem to have the will nor the knowledge to produce the quality they once did.

Gord   426 Surprise.



> On Mar 28, 2024, at 4:46 PM, Stephen Gwyn via Public-List <public-list at lists.alberg30.org> wrote:
> 
> I've had bronze welded on to the fitting at the top of the rudder post and
> then machined back. That was an amazingly tight fit but it didn't
> last long. And it was expensive.
> 
> I have put a brass bushing inside the arms of the tiller head fitting. I
> made it a very tight fit which also bent the arms out a bit. That is now
> about 3 years old and seems to be lasting better.
> 
> Under no circumstances buy a new tiller head fitting from Edison. Very
> expensive and very expensive shipping. And absolute crap. The hinge hole
> was drilled at least 10 degrees off true and the fit was much looser than
> the existing 50 year old fitting. I could have done better and I am
> terrible at this kind of work.
> 
> Your bar stock solution sounds good, but I would up the thickness to 1/4".
> 
> SG
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org



More information about the Public-List mailing list