[Public-list] thru hulls and seacocks and ball valves

Todd Redhead todd.redhead at sympatico.ca
Fri Jul 16 15:26:11 PDT 2004


Dan,

I did mine with ball valves.  The idea is that the seacocks are a little
stronger and more stable.  However, I just could not justify the cost - the
seacocks are at least 2x the price of ballcocks.  I think the problem is
that if you have a ballcock that is blocked or stuck that you could
potentially break it off at the thruhull when trying to close the arm.  I
have decided that operating all my ballvalves every couple of weeks should
keep them free and will hopefully prevent the problem from happening.  I
also keep wooden plugs near each thruhull incase of this type of problem.

Todd

----- Original Message ----- 
From: "dan walker" <dsailormon at yahoo.com>
To: "Alberg 30 Public List -- open to all" <public-list at alberg30.org>
Sent: Friday, July 16, 2004 6:15 PM
Subject: [Public-list] thru hulls and seacocks and ball valves


> well i went to my local handy dandy west store and the chap says i shold
not put in ball valves, i should put in seacocks. everybody agree and think
this is necessary?
> also dont seem to carry half inch seacocks. only three quarte so i would
need to change all the half inch thru hulls to 3 quartetr.
> oh the despair\
>
> thanks
> dan
>
>
> ---------------------------------
> Do you Yahoo!?
> New and Improved Yahoo! Mail - Send 10MB messages!
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list
>
> __________ NOD32 1.742 (20040428) Information __________
>
> This message was checked by NOD32 Antivirus System.
> http://www.nod32.com
>
>


 1090016771.0


More information about the Public-List mailing list