[Public-list] Port light installation on older Alberg

[sousa, stephen (ENG)]

George,

I had them made from stainless which was a very expensive venture. The cost
of frames and a new set of chain plates as approx. $1000. These were laser
cut which provided a frames that is seamless.

Stephen
#114 

-----Original Message-----
From: public-list-bounces at alberg30.org
[mailto:public-list-bounces at alberg30.org] On Behalf Of George Dinwiddie
Sent: Monday, August 15, 2005 11:25 PM
To: Alberg 30 Public List -- open to all
Subject: Re: [Public-list] Port light installation on older Alberg

Coolray wrote:
> A30s,
> What have you folks done in the past if the frames are
> beyond salvage? The repair page I read (very helpful
> and explicit) assumed good frames. 
> 
> John Cooler
> Atalaya

I seem to recall someone having new frames fabricated, cut out of 
stainless steel plate.  The original aluminum frames are a bar which is 
formed and then welded.

  - George

-- 
  ----------------------------------------------------------------------
   When I remember bygone days                         George Dinwiddie
   I think how evening follows morn;            gdinwiddie at alberg30.org
   So many I loved were not yet dead,           http://www.Alberg30.org
   So many I love were not yet born.
                                             'The Middle' by Ogden Nash
  ----------------------------------------------------------------------



_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list

 1124191380.0