[Public-list] Mast step repair

George Dinwiddie gdinwiddie at alberg30.org
Thu Jan 6 08:35:35 PST 2005


Peter,

If your liner is bulging, then the deck has sagged significantly. 
Probably that means that the beam has sagged.  Once you repair that, 
jacking it back to it's original place in the process, the sag in the 
liner should go away.  Possibly it will need a little help with a jack, 
but it should go back.  I don't think you need to epoxy it to the 
underside of the deck, as it wasn't done so originally.

  - George

Peter Amos wrote:
> I am clear in my mind how to go about the topside procedure for this
project but not so sure about fixing the bulging liner below.Two methods
seem possible,drill some holes in the GRP below the core and pump in
some thickened epoxy,then jack up the liner so that it spreads out ,then
carry on with the topside work.Alternatively finish the topside
work,remove the jack,drill some holes in the liner from below pump in
epoxy and jack the liner up again.In both method the liner is bonded to
the deck GRP.Am I looking at this the right way?

-- 
  ----------------------------------------------------------------------
   When I remember bygone days                         George Dinwiddie
   I think how evening follows morn;            gdinwiddie at alberg30.org
   So many I loved were not yet dead,           http://www.Alberg30.org
   So many I love were not yet born.
                                             'The Middle' by Ogden Nash
  ----------------------------------------------------------------------




 1105029335.0


More information about the Public-List mailing list