[Public-List] gate valves & ancient through-hull fittings & 5200: BEWARE

George Dinwiddie gdinwiddie at alberg30.org
Wed Nov 25 16:00:01 PST 2009


Randy Katz wrote:
>      Which leads to a final bit of advice with which some may argue: avoid
> 3-Ms 5200 for these parts.  The more forgiving, less concrete-like 4200 is
> perfectly adequate and immensely more forgiving.  When they say the 5200 is
> permanent, they mean it.  Take the easier and just as safe and effective
> route with 4200.

There's not problem using 5200 with any part you can heat.  A propane 
torch will soften it in no time. (Learned that from Bruce Rankin.)

  - George

-- 
  ----------------------------------------------------------------------
   When I remember bygone days                         George Dinwiddie
   I think how evening follows morn;            gdinwiddie at alberg30.org
   So many I loved were not yet dead,           http://www.Alberg30.org
   So many I love were not yet born.                          also see:
                'The Middle' by Ogden Nash     http://idiacomputing.com
  ----------------------------------------------------------------------




 1259193601.0


More information about the Public-List mailing list