[Public-List] drilling SS

[Roger L. Kingsland]

Thanks Mike, I can do slooooooow. 


-----Original Message-----
From: public-list-bounces at lists.alberg30.org
[mailto:public-list-bounces at lists.alberg30.org] On Behalf Of Mike Lehman
Sent: Wednesday, November 03, 2010 5:05 PM
To: Alberg 30 Public List -- open to all
Subject: Re: [Public-List] drilling SS


Carbide drills, light weight machine oil, and sloooooooow

 
Mike Lehman 

 
><((((º>`·.¸¸.·´¯`·.¸><((((º>`·.¸¸.·´¯`·.¸><((((º>
 
 






 
> From: r.kingsland at ksba.com
> To: public-list at lists.alberg30.org
> Date: Wed, 3 Nov 2010 16:51:06 -0400
> Subject: [Public-List] drilling SS
> 
> Hi Folks,
> 
> About to start drilling many 3/16" to 1/4" holes in 1/4" stainless 
> steel
> (316) plates. Can any machinist types out there please recommend drill 
> bit type, lubricant, drill press rotation speed, anything else?
> 
> Thanks very much,
> 
> Roger 148
> 
> 
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
 		 	   		  
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org



 1288818600.0