[Public-List] Diesel Help

Meinhold, Michael J. MICHAEL.J.MEINHOLD at saic.com
Tue Apr 12 07:42:27 PDT 2011


Thank you all for making me happy I still have an Atomic 4.....

Mike
Rinn Duin #272

-----Original Message-----
From: public-list-bounces at lists.alberg30.org
[mailto:public-list-bounces at lists.alberg30.org] On Behalf Of
moiraeiii at aol.com
Sent: Monday, April 11, 2011 4:24 PM
To: spiresac at yahoo.com; public-list at lists.alberg30.org
Subject: Re: [Public-List] Diesel Help

Thought I would chime in on this topic. My experience has been that
RPM's are necessary for these Volvo's to start, unless you use a
starting fluid, and that is not a recommended method for everyday
starting. Use the 'cold start lever' and engage the decompression
levers. Engage the starter get the flywheel spinning then drop the
decompression levers. I use the 'twenty minute rule'. Idle the engine
for a few minutes before running at cruising RPM's, as Capt. Bill
suggests, for a minimum of 15 minutes. Throttle to idle RPM's for a few
minutes before shutting down.
Good fuel and fuel filters along with CLEAN air for the Volvo to breathe
and you and your engine will be happy for a long time.


Randy #283





-----Original Message-----
From: spiresac <spiresac at yahoo.com>
To: Alberg 30 Public List -- open to all
<public-list at lists.alberg30.org>
Sent: Mon, Apr 11, 2011 11:52 am
Subject: Re: [Public-List] Diesel Help


I ran an old worn out Yanmar for years and I also run some other old
diesels.  
On the yanmar I would release the compression release, start spinning
the engine 
with the starter, hit it with a very, very brief hit of starting fluid
and close 
the compression release.  I find this is easy on the engine rings,
starter and 
me.  Be careful if you crank the starter for long because the injector
is 
spraying fuel and can cause a hydraulic lock in the engine.  WD 40 can
also be 
used to start the engine.  You might also check for a dead cell on the
batteries 
because this can make bad worse.  The other thing I have seen is that a
lot of 
old sail boat engines don't get run hard enough and long enough to keep
them 
healthy.  If you have not burned out the fuel lately or changed the
filters 
start with those.  Diesels like to run close to max (80 percent or so)
of max 
rpm for hours at a time.  I have seen this restore compression and
improve 
starting in many boat engines.  Diesels do not like
  to idle or run at partial throttle for long or be run for short
periods of 
time like most small boat engines are run. This Model yanmar is good for
over 
20,000 hrs and they run best when run hard and often.   My guess is that
you can 
get some more life out of this engine.

Capt. Bill
Sent from my Verizon Wireless BlackBerry

-----Original Message-----
From: Jonathan Adams <laughing_gull at verizon.net>
Sender: public-list-bounces at lists.alberg30.orgDate: Mon, 11 Apr 2011
10:19:51 
To: <public-list at alberg30.org>; Alberg 30 Member
List<member-list at lists.alberg30.org>
Reply-To: Alberg 30 Public List -- open to all
<public-list at lists.alberg30.org>
Subject: [Public-List] Diesel Help

Well I finally have a question that I really need an answer to - versus
one 
where I am looking for an opinion!

I have a Yanmar 2GMF. It is between 20 and 25 years old, and for the
last couple 

of years has been having a hard time starting - I might have to crank
the engine 

for a number of extended periods - minutes. This spring, I had Bayshore
Marine 
look at the engine, and they checked injectors and performed a
compression test. 

The injectors are fine, and the engine once started runs well. If it is
warm, it 

starts immediately no problem. Once running, it can hit its top revs
(~4k+) 
under no load - which indicates that the fuel pump / timing is good.

The result of this visit - other than lightening my wallet - was that
the lack 
of compression was creating the problem. It is meant to be 469lbs and is
400 in 
#1 and 415 in #2. The only way to deal with this is to check either the
head or 
the piston rings. Either way it is an expensive proposition. can I get
it to 
last the season? It is only a matter of time before I burn out the
starter motor 

and / or drain my batteries.

The mechanic recommended:

1. release the compression on the cylinders, and crank the engine to
warm things 

up, and then start

2. While doing this close the water intake valve, as the  muffler has no
exhaust 

to speak of when you are cranking and will fill up with water which
could back 
into the engine.

3. He recommended putting CRC into the air intake to help seal the
pistons. He 
did not recommend starting fluids as these damaged seals. Someone else
has 
recommended putting in heavier oil.

Any advice from the crowd? If I send the engine to Bayshore, I
essentially get a 

new engine, as they will warrenty it, and totally overhaul it while it
is out. 
However, this is sure to seriously impact the boat fund. Any
recommendations for 

a good mechanic that is not a crack head? The reason I went back to
Bayshore was 

I kept running into crack head mechanics.

Jonathan
197
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

 
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

 1302619347.0


More information about the Public-List mailing list