[Public-List] Drain plugs

Gordon Laco mainstay at csolve.net
Mon Dec 3 09:16:16 PST 2018


That’s pretty much what I do… teflon tape AND the same grease we use on Voyager fasteners.   

Gordon Laco
#426 Surprise




> On Dec 3, 2018, at 12:13 PM, Rod Symmes via Public-List <public-list at lists.alberg30.org> wrote:
> 
> Gord:
> A plumbing lesson that might give you further food for thought.
> For years I winterized a couple of water pumps at the cottage by pulling the drain plugs. One spring the threads were so rusted that I too had to run a tap in order to install the plugs.  That is when I realized that a lot of the rust occurred because of exposure to air. (even more of a problem with cast iron plugs)  My new routine is to pull the plug and while it drains, rap fresh Teflon tape on the plug, then re-install.  I always have clean threads and no searching for the "safe" place I put them.
> 
> Rod
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org




More information about the Public-List mailing list