[Public-List] Traveller Install

Wes Gardner wesgardner1952 at gmail.com
Wed May 2 11:06:32 PDT 2018


Hi Chris,

Here's a link to a pic.  The red line is the traveler control.
https://www.dropbox.com/s/5a1y7k53clyhgm8/Turning%20block%20after.jpg?dl=0

Wes

On Wed, May 2, 2018 at 2:01 PM, Wes Gardner <wesgardner1952 at gmail.com>
wrote:

> Hi Chris,
>
> Additionally, mine is a Lewmar traveler that came with cam cleats at
> either end for stopping off the traveler control line.  I bent mine up at
> an angle so they are easier to get the line back into the jaws of the cam,
> made alot of difference!
>
> Wes
>
> On Wed, May 2, 2018 at 1:50 PM, Wes Gardner <wesgardner1952 at gmail.com>
> wrote:
>
>> Hi Chris,
>>
>> The one I installed isn’t Garhauer, but mine did bend to the camber of
>> the deck without any issue. My guess is that yours will to. Use fender
>> washers on the underside and you’ll be fine
>>
>> Wes
>> #196
>>
>> Sent from my iPhone
>>
>> > On May 2, 2018, at 11:27 AM, Chris Martin via Public-List <
>> public-list at lists.alberg30.org> wrote:
>> >
>> > Hi Folks
>> > I have a new Garhauer traveller to install and am looking for some
>> advice. I have lots of questions and figure some have this setup and might
>> have some pointers for installation. I found some good info in the past but
>> I'm ready to get some hardware and didnt see that. What size and type
>> screws/bolts did you use? Also, seems like I can fab some tapered wood
>> pieces to mount the under the traveller or try to make the straight track
>> bend to the deck. Not much of a curve but its there. What works? Any other
>> issues I'm not thinking about?
>> > Thanks
>> > Chris
>> > _______________________________________________
>> > These businesses support your Association:
>> > http://www.alberg30.org/store/A30supporters.html
>> > Please support them.
>> > _______________________________________________
>> > Public-List mailing list
>> > Public-List at lists.alberg30.org
>> > http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>>
>
>



More information about the Public-List mailing list