[Public-List] Sanding the reverse (concave) curve where the keel and hull meet

[Jonathan Bresler]

Thank you to everyone for your recommendations on how to sand the reverse
curve where the keel joins the hull.  With your guidance,  I am being
successful in getting the job done.

All the best,
Jonathan

On Mon, Feb 7, 2022 at 00:03 Michael Connolly <crufone at comcast.net> wrote:

> Jonathan,
> Use your current sander at about a 45 degree angle to the concave surface.
> Apply only light pressure. It will work fine, takes some practice. Keep it
> moving at all times.
> Michael
> > On 02/06/2022 8:53 AM Jonathan Bresler via Public-List <
> public-list at lists.alberg30.org> wrote:
> >
> >
> > Folks,
> >
> > When sanding the hull to remove old paint, how do you sand the reverse
> > (concave) curve where the keel meets the hull of an Alberg 30?
> > Currently using a 5" DA sander to remove paint from the hull and keel.
> The
> > sander does not fit into the reverse curve.
> >
> > All the best,
> > Jonathan
> >
> > --
> > Jonathan M Bresler
> > S/V Constance Alberg 30 #262
> > Annapolis/Eastport MD
> > _______________________________________________
> > These businesses support your Association:
> > http://www.alberg30.org/store/A30supporters.html
> > Please support them.
> > _______________________________________________
> > Public-List mailing list
> > Public-List at lists.alberg30.org
> > http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>
-- 
Jonathan M Bresler
S/V Constance Alberg 30 #262
Annapolis/Eastport MD